As homes settle over time, shifting wall framing may lead to unsightly cracks in a wall's drywall finish. Wall framing may also pull away from the drywall due to moisture or small movements in the.
- Wall Crack Repair Spray
- Interior Wall Crack Repair Products
- Basement Wall Crack Fix
- Exterior Wall Crack Repair
Fixing Cracks in Drywall. To repair cracks in walls made of drywall usually requires these tools: a utility knife; a paintbrush or vacuum; spackling compound or joint compound; a putty knife; sandpaper and a sanding block; primer and paint; For large cracks, patching tape may be needed. Fixing Cracks In Concrete Walls 1. Use a wire brush to clean the crack of all dirt, grease and loose grit. Then vacuum up any residual dust and debris. Tap in a 3-in. Finishing nail every 12 in. Along the entire crack. The nails will be used to align the injection ports. Mix together equal.
Gather your materials.
You’ll need a 6-inch taping knife, a 10- or 12-inch taping knife, 1 square piece of plywood or a plastic mud pan, drywall compound, drywall tape (paper or fiberglass), and fine-grit sandpaper and a sanding block.
Clean out the crack.
Use your taping knife to scrape the edges of the crack to remove any dust.
Put some compound on the plywood or mud pan.
This makes it easy to load onto the knife.
Apply a light coating of compound to the crack using the 6-inch taping knife.
Make sure that the coating is wet but not thick.
Embed the tape in the compound immediately.
Wall Crack Repair Spray
Lay the tape over the compound you just applied and use the knife to push the tape into the compound. If necessary, cut the tape in short lengths to follow the line of a really crooked crack.
If you bought fiberglass tape, you can skip the embedding coat of compound under the tape because it is self-sticking. Otherwise, you do everything the same way.
Warning: Fiberglass tape is thicker than paper tape, which makes it harder to repair invisibly.
Scrape the tape with the wider knife to scrape away any excess compound.
Use a smooth scraping motion.
Apply a thin coat of compound over the tape using the 6-inch knife.
Be sure to feather the edges. Let the patch dry completely (usually overnight).
After the first coat is dry, apply a second coat with the wide knife.
By using a wider knife, you blend out the original edges. Make sure to feather the edges again. Again, let it dry.
Allow to dry and then apply a final coat.
Interior Wall Crack Repair Products
Follow the same procedure as before.
Sand the patch until smooth.
Use a fine-grit paper to smooth out the surface.
Paint over the patch with primer.
Basement Wall Crack Fix
Don’t skip this step or you’ll end up with a permanently goofy-looking, non-matching area.
Apply touch up paint to the patch in your wall color.
Exterior Wall Crack Repair
This is why you saved that half a gallon of leftover wall paint.